Sep 18, 2017 · Open boot, latch boot to make the car think it is closed. Disable internal alarm sensors and close the door and lock it. Wait some time to allow systems to shut down. Carefully remove the battery terminal clamp whilst keeping a constant connection with a multimeter set to measure current. Dec 23, 2012 · Reply Share. A6 / S6 (C6 Platform) Discussion - Fuel Supply Sensor Fault? - Ran the vagcom and got the following fault: 1 Fault Found: 00438 - Fuel Supply Sensor 2 (G169) 010 - Open or Short to Plus - Intermittent Freeze Frame: Fault Status: 00101010 Fault Priority: 7 Fault Frequency: 16 Reset counter: 116 Mileage: 111139 km Time Dec 14, 2016 · Another strange thing is that tonight the battery level screen showed that the battery was 100% charged and after a few hours i went to check on it and it would not start once again and the screen showed the battery at 0%. Nov 25, 2017 · A6 / S6 (C6 Platform) Discussion - battery levels - I have a 2006 audi a6 that is not currently in use. whenever i go out to check the battery level sometimes it will show that the battery level is full and sometimes it will show that the battery is on its last notch. any ideas on what could be draining the battery. Jul 13, 2022 · However since the HV battery was discharged chances are 48v system is disabled you need to latch 48v contactor in order for 48v battery to take a charge. I believe this is part of battery monitoring module 2. Not sure if VCDS will do it. I use ODIS to latch the contactor then try charging the battery. Apr 7, 2016 · Step 2 – Check the brake pedal switch. Through wear and tear, this plastic switch, located on the brake pedal assembly, can fail with age. The easiest way to do this is to turn the car on and, while the brake notification is lit up on the dashboard, walk around to the back to see if the brake lights are on. This indicates the brakes are being .

audi a6 c6 battery level